E106 Wired Sensor LED Patterns

The VergeSense E106 wired area sensor contains an LED next to the soft reset button on the side of the sensor. The LED is intended to provide an indication of the sensor's status during initialization. During normal operation, the LED will be turned off and the sensor's status should be visible in the VergeSense dashboards. Below is a guide to the LED patterns and their meanings.

Boot Sequence LED Patterns

See the legend below for the table's background color meanings:

Color	State	Pattern
Cycle through red, green, and blue	Initial power and system initialization (approximately 30 seconds)	Approximately 0.5 seconds on each color.
Green	System initialized	Solid on
Green	Searching for Network address	Flashing - approximately 0.5 seconds on/off cadence
Blue	Connecting to VergeSense Cloud	Flashing - approximately 0.5 seconds on/off cadence
Off	Normal operation	Off

= Device is still booting.

= Device has fully booted.

Applying Network Configuration LED Patterns

If a network configuration is to be applied to the sensor via the USB port, the LED will exhibit the following behavior upon insertion of the USB stick.

Note: Ensure the sensor has fully booted before inserting the USB stick. The sensor is considered fully booted once it reaches the Searching for Network address state or any later state listed in the table above.

Color	State	Pattern
Blue	Reading network configuration file	Solid on
Green	Searching for Network address	Flashing - approximately 0.5 seconds on/off cadence
Blue	Connecting to VergeSense Cloud	Flashing - approximately 0.5 seconds on/off cadence
Off	Normal operation	Off