G400 Gateway LED Patterns

The VergeSense G400 gateway has an LED next to the soft reset button on its side, designed to indicate the gateway’s status. Below is a guide to the LED patterns and their meanings.

Note: When you first power on your new G400 out of the box, it may display a red LED for an extended period as it initializes. This should occur only during the initial startup when it's plugged in for the first time.

Boot Sequence LED Patterns

See the legend below for the table's background color meanings:

Color	State	Pattern
Cycle through yellow, purple, and green	Initial power and system initialization (approximately 30 seconds)	* Solid yellow (1 second) * Solid purple (3–5 seconds) * Solid green (10–12 seconds)
Green	System initialized	Solid on
Green	Searching for Network address	Flashing - approximately 0.5 seconds on/off cadence
Blue	Connecting to VergeSense Cloud	Flashing - approximately 0.5 seconds on/off cadence
Off	Normal operation	Off

= Device is still booting.

= Device has fully booted.

Applying Network Configuration LED Patterns

If a network configuration is to be applied to the gateway via the USB C port, the LED will exhibit the following behavior upon insertion of the USB stick.

Note: Ensure the gateway has fully booted before inserting the USB stick. The gateway is considered fully booted once it reaches the Searching for Network address state or any later state listed in the table above.

Color	State	Pattern
Blue	Reading network configuration file	Solid on
Green	Searching for Network address	Flashing - approximately 0.5 seconds on/off cadence
Blue	Connecting to VergeSense Cloud	Flashing - approximately 0.5 seconds on/off cadence
Off	Normal operation	Off